Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
- 13. Body
   13.1. Introduction
   13.2. Care of a body
   13.3 Care of an upholstery and rugs
   13.4. Repair of insignificant damages of a body
   13.5. Repair of strong damages of a body
   13.6. Cowl
   13.7. Replacement of the lock of a cowl
   13.8. Replacement of a cable of the lock of a cowl
   13.9. Front grille
   13:10. Front bumper
   13:11. Rear bumper
   13:12. Forward wing
   13:13. Door upholstery
   13:14. Lock, cylinder of the lock and handle of opening of a door
   13:15. Door glass
   13:16. Window regulator
   13:17. External mirror
   13:18. Doors
   13:19. Trunk lid
   13:20. Luggage carrier lock
   13:21. Cable of opening of the lock of a luggage carrier
   13:22. Replacement of racks of support of a back door
   13:23. Back door
   13:24. Lock of a back door, external handle and cylinder of the lock
   13:25. Casings of a steering column
   13:26. Central console
   13:27. Dashboard elements
   13:28. Dashboard
   13:29. Air inlet lattice
   13:30. Front seats
+ 14. Electric equipment


2d841be8


13.8. Replacement of a cable of the lock of a cowl

PERFORMANCE ORDER
1. Disconnect a cowl lock cable from the cowl lock.
2. Disconnect a cable from fastening brackets (are specified by shooters) in a motor compartment.
3. Tie a thin strong cord to the end of a cable of a cowl.
4. In interior of the car remove the lower casing of the dashboard from the driver.
5. Unscrew screws of fastening of the handle of opening of a cowl.
6. Disconnect a cable from the handle of opening of a cowl.
7. Take an old cable of opening of a cowl through a partition of a motor compartment in interior of the car.
8. Untie a thin cord from a cable of opening of a cowl and leave it in a partition of a motor compartment.
9. Replace a sealing ring of a cable of opening of a cowl in a partition of a motor compartment.
10. Tie a cord to the end of a new cable of opening of a cowl and for a cord involve a cable in a motor compartment.
11. Further installation is made in the sequence of the return to removal.