Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
- 14. Electric equipment
   - 14.1. Body electric equipment
      14.1.1. Introduction
      14.1.2. Electric chains
      14.1.3. Detection of not closed chain
      14.1.4. Safety locks
      14.1.5. Chain breakers
      14.1.6. Relay
      14.1.7. Relay of turns and alarm light system
      14.1.8. Multipurpose switches of a steering column
      14.1.9. Ignition lock
      + 14.1.10. Replacement of switches of the dashboard
      14.1.11. Combination of devices
      14.1.12. Radio receiver
      14.1.13. Loudspeakers
      14.1.14. Antenna
      14.1.15. The antenna with the electric drive
      14.1.16. Replacement of bulbs of headlights
      14.1.17. Adjustment of light of headlights
      14.1.18. Headlight
      14.1.19. Replacement of bulbs of an incandescence
      14.1.20. Screen wiper engine
      14.1.21. Sound signal
      14.1.22. Check of a heater of back glass
      14.1.23. Window regulators with the electric drive
      14.1.24. Rear-view mirrors with the electric drive
      14.1.25. Safety airbag
   + 14.2. Electrical circuitries


2d841be8


14.1.6. Relay

GENERAL INFORMATION

Relay arrangement in a motor compartment of cars from 1990 to 1994


Relay arrangement on the dashboard on cars from 1990 to 1994


Relay arrangement in interior of the car on models from 1990 to 1994


Arrangement of the relay and sensors on models since 1995

1 – switch of automatic equipment (model 2WD)
2 – sensor of pressure of the air conditioning system
3 – oil pressure sensor
4 – main block of safety locks
5 – relay of a left headlight
6 – relay of a right headlight
7 – air conditioning compressor relay
8 – N2 radiator fan relay
9 – N2 radiator fan
10 – main relay of the N1 fan
11 – fuse of the air conditioning system

Arrangement of the relay and other electric components on the dashboard on models since 1995

12 – executive mechanism
13 – fan relay
14 – relay of a sound signal
15 – block of fuses
16 – block of turns and emergency
light alarm system
17 – relay of back fog
lamps
18 – back dimensional lamp and relay of lighting
19 – main relay of the fan
20 – seat belt timer
21 – illumination adjustment block
22 – control unit of the shift lock
23 – relay of disconnection of a chain of the power window
24 – power window and relay of the hatch
25 – control socket
26 – fan engine resistor
27 – timer of the door lock
28 – the executive feeder of the fresh or recirculated air
29 – evaporator thermoswitch

The relay is an electronically controlled switch which is usually used as follows.

The relay can switch big currents remotely from a chain in which this current flows, allowing to use thinner wires and contacts of switches.

The relay can have more than one managing director of an entrance unlike the mechanical switch.

The relay can perform function of the timer, for example, to set an interval of work of screen wipers.

If the system operated by the relay fails also a cause of defect, perhaps, the relay is, listen to operation of the relay at the included system. If the relay regularly works, then you have to hear click at its inclusion. If the relay is serviceable, then the cause of defect is concluded in elements or the connecting wires. If the relay does not work, it means that it does not receive the main power supply or the operating impulse or the relay is faulty.
On the majority of the relay on the case of the relay the electric circuit and an arrangement of contacts of the relay is put.